5. Why are there tiny cracks on the surface of the product?
Answer: When the paper product is formed, the pulp fibers are naturally absorbed into a clump, and the liquid pulp cannot flow out in several grooves. The thickness of the different positions after the paper is dried is different from the standard thickness in the design, so it is subjected to strong external forces during high-pressure shaping. During compression, the outermost fiber breaks where the inner and outer thickness is uneven, and the surface shows tiny cracks. This phenomenon will not affect the packaging strength of paper pallets, so it can be accepted in the industry.
6. Why can't my product be deducted?
Answer: Cardboard pallets (pulp forming) products are closed up and down during forming and shaping, and a certain draft angle is required. Wet products cannot be demolded during forming, and cardboard pallets cannot be designed with inverted buckles.
7. Why are there deviation burrs around the flanging product?
Answer: The flanging structure product is formed into a flat edge. The edge of the mold is a stainless steel filter when the vacuum is formed to absorb the pulp naturally. After the pulp fiber is adsorbed, the edge is irregular cotton-like. This is formed by technology that cannot be controlled. The burr flanging behind the edge does not affect the packaging and is not used as a production control element in the industry. If the customer has high requirements for this, you can use a knife to cut, and use a knife to cut the burr.
8. Why set up MOQ?
Answer: After the production of paper pallets, after pulping, forming molds, adjusting molds, and drying, the molds are heated for about 30 minutes after shaping. If the quantity is too small, the production cost will rise significantly. The paper pallets are low value-added products, and the quantity is too high. Less, transportation costs have also risen sharply. Therefore, MOQ must be set.
9. Why can't you design according to the size I requested?
Answer: First, the size is too large. The length and width of the table used in the general industry is limited to 800mmX600mm. The special model is 1500mmX1200mm. It cannot be produced beyond this size.
The second is that the design size is too small, and the paper support is designed to buffer and shockproof, which requires a certain amount of structural design space.
Address: Pinghan Village Committee Industrial Development
Zone, Gonghe Town, Heshan City
Phone:0750- 8307312
Mobile:18138060289(Mr. Li) 13266450566(Mr. Lin)
Email:1315998615@qq.com
Follow WeChat | public account |